USER’S GUIDE

[IP RIP] Unable to open RIP/UDP port 520

The UDP port for RIP was unable to be opened. There are 63 possible UDP ports, and none are available for use at this time. No RIP information can be transmitted or received. Contact your Distributor or Customer Support.

[IP RIP] Unable to register WAN Connection notification

The IP RIP protocol was unable to register with the IP WAN interface connection notification system. No WAN connection information will be reflected in the RIP packets. Contact your Distributor or Customer Support.

[IP RIP] Unable to register with Network Interface Maintenance

The IP RIP protocol was unable to register with the IP network interface notification system. Any dynamic changes of the network interface configuration will not be reflected in the RIP interface control. Contact your Distributor or Customer Support.

[IPX] Invalid IPXWC passed

In the unlikely event this message is posted, contact your Distributor or Customer Support.

[IPX] Network initialized successfully on xxxxxxxx:xxxxxxxxxxxx

This message is posted when the numbered interface is successfully initialized on the indicated IPX address.

[IPX] Network Interface on LAN port <port #> not initialized

The network interface for the LAN port indicated was not initialized because there is no Ethernet resource configured, or the Ethernet resource that is configured does not have the corresponding port. You should correct the system configuration.

[IPX] Route <IPX network address # 1> not added: invalid next hop(<IPX address # 2>

The static route entry indicated by the <IPX network address #1> was not added in the IPX routing table because the next hop indicated by the <IPX address #2> is not located on any network directly connected to the configured network interface.

[IPX] Route (<IPX network address>) not added: invalid next hop (<name>)

The static route entry indicated by the <IPX network address> was not added in the IPX routing table because the next hop remote device indicated by the <name> does not exist.

[IPX] IPX router initialized successfully

This message is posted when the IPX Router feature has initialized successfully.

IPX spoofing unable to get disconnect time structure. Default options replacing disconnect time options for device <device name>.

The resources required to properly perform the configured IPX spoofing options for the specified device after a connection to this device has been disconnected could not be obtained. The default IPX spoofing options are being used in place of the disconnect time IPX spoofing options.

[IPX RIP] Buffers allocated

The IPX RIP successfully allocated the buffers needed to transmit IPX RIP packets.

[IPX RIP] RIP Protocol Initialization successful

The IPX RIP protocol was successfully initialized.

458 CyberSWITCH

Page 458
Image 458
Cabletron Systems CSX1000 manual IP RIP Unable to open RIP/UDP port, IP RIP Unable to register WAN Connection notification