Cabletron Systems CSX1200, CSX1000 manual Routing

CONFIGURING DEVICE LEVEL DATABASES

On-node Device Entries

a.Enable or disable IPX routing.

b.If you enable IPX routing and want dial-out capabilities to this device, enable the Make Calls feature.

c.If you enable IPX routing, you may enable or disable IPXWAN protocol.

d.If you enable IPX routing, select IPX Routing Protocol. Select a routing protocol of none, RIP/ SAP, or Triggered RIP/SAP. When you select Triggered RIP/SAP, you will need to identify the WAN peer type as either active or passive.

e.You may also select Spoofing Options. Make changes to default spoofing setup, if desired.

Refer to IPX Information for Devices and Configuration Elements for more information.

11.To enter any needed AppleTalk information for your device, select AppleTalk from the Device Table Menu. The following screen will be displayed:

Device AppleTalk Menu: (device = “DAN”)
1)	AppleTalk	Routing	DISABLED
2)	AppleTalk	Address	None
3)	Make calls for AppleTalk data		DISABLED
4)	AppleTalk	Routing Protocol	None
Select function		from above or <RET> for previous menu: 1

a.Press 1 at the above menu, then follow the on-screen instructions to enable AppleTalk routing for the device.

b.Press 2 at the above menu to enter the device’s AppleTalk address. If the device is over an unnumbered link, enter 0.0. If the device is over a MAC dial-in port, you may either enter an address, or leave the value at “none”.

c.Press 3 at the above menu, then follow the on-screen instructions to configure whether or not dial out to this device is allowed for this device.

d.Press 4 at the above menu to specify an AppleTalk routing protocol the system should use with this device. The options are None or RTMP. Currently RTMP is only supported for

devices who will be dialing into the CyberSWITCH via a MAC dial-in port.

Note: If you are configuring a device for AppleTalk Remote LAN, leave the above AppleTalk information at the default values (DISABLED, None, DISABLED, None).

Refer to AppleTalk Configuration Elements for more information.

12.To enter any needed bridge information for this device, select Bridge from the Device Table Menu. The following screen will be displayed:

Device Bridging: (device = "DAN")
1)	IP (Sub)Network number	NONE
2)	Bridging	ENABLED
3)	Make Calls for Bridge data	NONE
4)	IPX Remote LAN Network Number	NONE
5)	IPX Spoofing Options
6)	AppleTalk Network Number	NONE
Select function from above or <RET>		for previous menu:

You may enable or disable bridging for this device. If this device is to use a Remote LAN interface or Remote LAN port, enable bridging. If you want dial out capabilities to this device, enable Make calls for Bridge data.

Workgroup Remote Access Switch 161