Cabletron Systems CSX1000, CSX1200 manual Snmp Configuration Elements

USER’S GUIDE

USING MANAGE MODE COMMANDS

Currently you cannot configure SNMP using the Manage Mode, but the following command is available:

snmp

This Manage Mode command displays the current SNMP configuration data. An example output screen is shown below:

MANAGE> SNMP

The SNMP feature is enabled.

Current SNMP COMMUNITY NAME Configuration:

id	MIB ACCESS	LEVEL	COMMUNITY NAME
---	-------------------------------------------
1	MIB_ADMIN		public
2	MIB_USER		user
3	MIB_ADMIN		test
Current SNMP TRAP		RECEIVER List Configuration:
id	IP ADDRESS		COMMUNITY NAME
----------------------------------------------
1	128.111.001.001		public
2	144.123.111.099		public
3	102.003.003.222		test
The generation of		Authentication Failure Traps is disabled.
The generation of		ISDN B-Channel Usage Traps is enabled.

The ISDN B-Channel Usage Trap threshold is 5 B-Channels.

SNMP CONFIGURATION ELEMENTS

SNMP STATUS

You may enable or disable the SNMP feature.

COMMUNITY NAME

A 1 to 20 character case-sensitive string that specifies a Community Name that will be accepted by the SNMP Agent if it is specified in an incoming Request PDU.

MIB ACCESS LEVEL

The MIB Access Level associated with a Community Name must be selected from the supplied list. It dictates the level of access available to the associated Community Name. The following is a chart of the three possible access levels and their access privileges.

Access Level	Access Privileges
MIB GUEST	get (read) MIB-2 system group only
MIB USER	get (read) all MIB-2 and Enterprise MIB objects
MIB ADMIN	get (read) all MIB objects and set (write) all MIB objects
	that are writable

300 CyberSWITCH