PROBLEM DIAGNOSIS

Bridge Initialization

BRIDGE INITIALIZATION

Problem:

The system does not display the following bridge initialization messages:

LAN Port <port #> is now in the LISTENING state

LAN Port <port #> is now in the LEARNING state

LAN Port <port #> is now in the FORWARDING state

Action:

1.Make sure the LAN Adapter has initialized correctly.

2.Check the configuration to verify the bridge is enabled.

IP ROUTING INITIALIZATION

Problem:

The system does not display the expected IP routing initialization messages.

Action:

1.If you did not see the following IP message:

[IP] IP router is initialized successfully

Check the configuration to verify that IP routing is enabled.

2.The failure to see the following IP message for each IP interface:

[IP] Network initialized successfully on ddd.ddd.ddd.ddd

indicates that you may have either not configured a needed interface or have incorrectly configured an interface. Check the system’s IP network interface configuration using the ipnetif command (a Manage Mode command). If there is a problem with the configuration, use the CFGEDIT to make corrections.

WAN LINE AVAILABILITY

Problem:

The system does not display the WAN line availability messages. Instead, the system displays the following message after the status console command is issued:

Line (slot #, port #) down

Action:

1.Verify that the line is correctly attached to the proper system resource and port.

2.If the line was correctly attached in action 1, try restarting the system.

3.If actions 1 and 2 fail to correct the problem, call your phone company (carrier) to check the status of the line.

Workgroup Remote Access Switch 385

Page 385
Image 385
Cabletron Systems CSX1200, CSX1000 manual Bridge Initialization, IP Routing Initialization, WAN Line Availability