Cabletron Systems CSX1000, CSX1200 manual No pvc configured for Device DAN

USER’S GUIDE

6.For Frame Relay devices:

Note: You must first configure the Frame Relay Access. Instructions for configuring the access is found in the Frame Relay Accesses section of the Configuring Alternate Accesses chapter.

Begin by selecting Frame Relay from the Device Table Menu. A screen similar to the following is displayed:

Device	Frame Relay Menu: (Device =			"DAN")
			Access Name		DLCI	Protocol
1)	PVC	Information	DANACCESS		16	PPP
You cannot		change this	information	from within this menu.

Press any key to continue

This screen will reflect your previously configured access information for a permanent virtual circuit associated with the device. This information is not configurable in this location.

Notes: If you receive the following message, ensure that the PVC Name matches the device name.

No pvc configured for Device "DAN"

In order to associate a device to a specific PVC, you must also provide authentication information (see step 9).

7.For X.25 devices:

Note: You must first configure the X.25 Access. Instructions for configuring the access is found in the X.25 Accesses section of the Configuring Alternate Accesses chapter.

Begin by selecting X.25 from the Device Table Menu. If the X.25 access is configured for both PVCs and SVCs, select the type of virtual circuit for the device:

Select the type of the Virtual Circuit

1)	Permanent Virtual Circuit (PVC)
2)	Switched Virtual Circuit (SVC)	[default 2]:

158 CyberSWITCH