Cabletron Systems CSX1200, CSX1000 manual Out Svc # slot # , port #, Over Max Charge

SYSTEM MESSAGES

System Message Summary

Out Svc # <slot # , port #>

ISDN line failure. The line connected to the indicated slot and port is out of service for the reason indicated by # .

1 = No layer 1 sync for 5 seconds

This problem normally occurs due to WAN cabling problems.

Check your cables to make sure they are connected correctly. If this problem still occurs after you have checked all the cables, call the phone company and report the problem.

2 = No response to TEI requests

This problem normally occurs due to invalid configuration. Check your configuration using the following table:

basic rate	line from phone co:	line from phone co:
	point-to-point	multi-point
line configured on non-	make sure that the	change TEI to be
auto TEI	configured TEI value	AUTO
	is 0
line configured on auto	change TEI to be non-	if problem happens
TEI	auto	for over 5 minutes,
		report problem to
		phone company

3 = No UA response to SABME requests; no Layer 2

This problem normally occurs due to invalid configuration. Check your configuration using the previous table.

4 = Failure to negotiate SPID (U.S. only). This is due to an improperly configured SPID. Check your configuration.

5 = Failure to negotiate SPID (U.S. only). SPID has not been configured on the system; check configuration.

Over Max Charge

Monthly call charges exceeded. Monthly call charge tracking is enabled and the configured maximum has been exceeded.

[PAP] Identification timeout on remote device

The remote device did not send the PAP Authenticate-Request packet within a required amount of time. Try again. If this persists, contact your remote site.

[PAP] Invalid password for <name> given by remote device

The system received the PAP Authentication-Request packet with the incorrect password for the device name <name>.

[PAP] Remote device did not respond to the request

The system sent PAP Authenticate-Request packets the maximum number of times, but the remote device did not send either Authenticate-Ack or Authenticate-Nak packets. The remote device may not be working properly. Check the configuration of the remote device and reboot. If the problem recurs, contact your Distributor or Customer Support.

Workgroup Remote Access Switch 467