Cabletron Systems CSX1200, CSX1000 manual Channel in use in Hostcallrequest

SYSTEM MESSAGES

System Message Summary

CHANNEL in use in HOST_CALL_REQUEST

The system software sent a message to the RBS state machine that the state machine was unable to recognize or the information was incorrect. If this message is displayed in the log messages, contact your Distributor or Customer Support.

[CHAP] Authentication Failure of remote device <device name> - <error message>

On-node or off-node (for example, through the RADIUS Server) CHAP authentication has failed. The <device name> will contain the device name configured in the Device Table. The <error message> will contain information that should aid in trouble shooting.

If the authentication failure is an on-node failure, the <error message> will contain one of the following strings:

Challenge Response failed hash calculation No Secret configured in Device Table Name not configured in Device Table Invalid information in authentication attempt

If the authentication failure is an on-node failure, the <error message> will contain one of the following strings:

Challenge Response failed in hash calculation No Secret configured in Device Table Name not configured in Device Table

If the authentication failure is an off-node failure, the remote Authentication Agent will generate the error message.

[CHAP] Authentication Failure - remote device not responding

The System has not received a challenge response from the peer. The cycle is attempted the configured number of times, after which a failure is declared. Check your remote device.

[CHAP] Authentication Failure - unable to initiate server transaction <return code>

The System authentication type is configured to obtain device information off-node, for example from a RADIUS server, but an internal error has prevented the transaction from occurring. Check the Radius Server report log for more information. If unsuccessful, contact your Distributor or Customer Support.

[CHAP] Remote device indicates Authentication Failure of system <data>

The System received a fail reply in remote CHAP mode. This means that the System has not been authenticated by the peer, and most likely the link will be released. <data> contains a portion of the received frame, which should aid in trouble shooting the situation.

Circuit-mode/Packet-mode aggregation will not be allowed, dropping oldest connection to site <site name>

This message may appear if switched calls are used to back up Frame Relay. If this message is seen infrequently, it merely indicates the changeover from Frame Relay to switched calls and back again. If this message is seen frequently, contact your Distributor. At the same time that these messages are displayed in the log, an open Monitor Connection window may show brief periods (<1 second) where the indicated Bandwidth suddenly increases and then decreases. This is due to the changeover between Frame Relay and switched calls and is not a problem.

Workgroup Remote Access Switch 439