USER’S GUIDE

VERIFYING IP ROUTING OVER A WAN REMOTE LAN INTERFACE

To verify that IP routing is properly operational over a WAN Remote LAN interface, a remote IP Host must be operational and connected to the remote LAN. The remote bridge device must be operational and available to initiate connections. Also, a local IP host must be connected to the local LAN port on the CyberSWITCH.

Below is an example of a configuration used to verify IP routing over a WAN Remote LAN interface. It uses IP addresses specific to the example. Substitute the IP addresses of your network when you perform the IP routing verification steps. It also uses the “ping” command. The “ping” command sends a packet to a specified host, waits for a response, and reports success or failure. Substitute the equivalent command on your IP host.

CSX1200

192.100.1.1

WORKGROUP REMOTE ACCESS SWITCH

ISDN

LINE

 

LINE

 

LINE

 

LINE

1

2

3

4

 

 

 

 

 

 

 

100.0.0.1

100.0.0.0

Bridge

Host B

192.100.1.3

Host A

100.0.0.2

The steps to verify the operation of IP routing over a WAN Remote LAN interface are:

1.Determine if a remote IP host can access the WAN Remote LAN interface of the CyberSWITCH over the WAN connection. On the remote IP host type:

ping 192.100.1.1 <return>

If the remote IP host successfully pings to the CyberSWITCH, then continue with the next step.

If the remote IP host CANNOT ping to the CyberSWITCH, refer to IP Routing over a WAN Remote LAN Interface Connection of the Problem Diagnosis chapter.

2.Determine if a remote IP host can access the LAN interface of the CyberSWITCH over the WAN connection. On the remote IP host type:

ping 100.0.0.1 <return>

If the remote IP host successfully pings to the CyberSWITCH, then continue with the next step.

If the remote IP host CANNOT ping to the CyberSWITCH, refer to IP Routing over a WAN Remote LAN Interface Connection of the Problem Diagnosis chapter.

3.Determine if a remote IP host can access the local IP host through the CyberSWITCH over the WAN connection. On the remote IP host type:

ping 100.0.0.2 <return>

364 CyberSWITCH

Page 364
Image 364
Cabletron Systems CSX1000, CSX1200 manual Verifying IP Routing Over a WAN Remote LAN Interface