Cabletron Systems CSX1200 Unexpected error during transmission of LMI frame, Unmatched Login Task

SYSTEM MESSAGES

System Message Summary

Unexpected error during transmission of LMI frame

A system error occurred during the actual transmit request for an LMI frame. Contact your Distributor or Customer Support.

Unknown Calling Bridge <MAC address>

MAC address security is enabled and the remote Combinet does not match any of the defined devices.

Unknown DLCI <dlci index> in CLLM message

The network has sent a CLLM message which has referenced the indicated DLCI that has not been configured. Check the system configuration for the indicated DLCI.

Unknown Security Association

An incoming datagram specifies a Security Parameter Index (SPI) which has not been defined on this node. Verify the encryption parameters on both nodes. Adjust if necessary so that both nodes reflect the same SPI.

Unmatched Login Task

This represents an internal system error. Contact your Distributor or Customer Support.

Unsupported Combinet protocol received: <protocol Id>

An unsupported Combinet protocol attempted to connect to the system. Contact your Distributor. You may need to upgrade software to support this.

Unsupported Combinet protocol version received: ‘<version Id>‘. [Device: <device name>]

An unsupported Combinet version attempted to connect to the system. Contact your Distributor. You may need to upgrade software to support this.

Updating CyberSWITCH from “<FileName>”

The specified file, received during a Reliable Remote Upgrade, was successfully loaded into memory and will now be verified before installation into the Flash File System.

User Level Authentication flag is enabled for Terminal User xxx. Setting flag to disabled.

The device definition for xxx should have User Level Authentication disabled.

These two messages are displayed together. In device entries for terminal server connections, user- level authentication should not be enabled. In the event the CyberSWITCH finds an enabled condition, it will disable the pertinent flag for the duration of the call only. To avoid this situation permanently, disable the user level authentication flag in device entries for all terminal server connections.

Waiting for WAN card in slot <slot #> to complete initialization

Download process update for WAN card in slot <slot #>.

WAN card in slot <slot # > signals it is operational

Download process update that indicates that WAN card in slot <slot #> is now operational.

WAN Port is now in the Forwarding state

WAN port connections used by the bridge are now entering the specified state.

WAN Port is now in the <new state> state

The WAN connection port used by the bridge is entering the specified new state.

Workgroup Remote Access Switch 483