Cabletron Systems CSX1200, CSX1000 manual IP Host Security Rejection Invalid Security ID Id string

SYSTEM MESSAGES

System Message Summary

[IP Host] Security Rejection - Invalid Security ID <Id string>

The system has received an IP Host Id, <Id string>, from a remote device that is not configured in the Device List. The system has rejected the incoming call. Verify that the IP Host ID in the Device List information is identical to the IP Host Id configured in the remote device.

[IP Host] Security Rejection - Security ID cannot be validated with Authentication Server

The System authentication type is configured to obtain device information off-node, for example from a RADIUS server; however, such transactions are not yet supported when IP Host ID Security is enabled.

[IP RIP] All network interfaces used

All RIP interface data structures are in use. No RIP information will be sent to any additional interfaces. Contact your Distributor or Customer Support.

[IP RIP] Buffers allocated

The RIP successfully allocated the UDP buffers needed to transmit RIP packets.

[IP RIP] Initialization failed, unable to allocate buffers

The RIP initialization was not completed. The machine contains insufficient memory to allocate the UDP buffers needed to transmit RIP packets. Contact your Distributor or Customer Support.

[IP RIP] RIP Protocol Initialization successful The RIP protocol was successfully initialized.

[IP RIP] Route Maintenance Registration Failed

The IP RIP protocol was unable to register with the IP routing table notification system. Any dynamic changes of the routing table configuration will not be reflected in the RIP packets sent to other routes. contact your Distributor or Customer Support.

[IP RIP] Send queue full

The RIP transmission queue has become full. This is not a normal occurrence. The machine should be restarted. If this message is displayed again after the machine has been restarted, contact your Distributor or Customer Support.

[IP RIP] Shutdown complete

The RIP protocol was successfully shutdown via Dynamic Management. No RIP routing information will be transmitted or received. Any routes learned via RIP will soon expire.

[IP RIP] Unable to add host route <IP address>

A failed attempt was made to add the host route to the IP RIP routing table. The routing table can have approximately 300 routing entries, and at this time, the routing table is full. The host route will not be broadcast via RIP packets and therefore other routers will not be able to learn the route to this device. You can use the packet capture commands to try to determine if a device is advertising an unusual number of routes. If you are unable to track down the problem, contact your Distributor or Customer Support.

[IP RIP] Unable to add route, routing table full

The IP RIP routing table is currently full, no new routes can be added. The routing table can have approximately 300 routing entries, and at this time, the routing table is full. This could result in possible unreachable destinations. You can use the packet capture commands to try to determine if a device is advertising an unusual number of routes. If you are unable to track down the problem, contact your Distributor or Customer Support.

Workgroup Remote Access Switch 457