Cabletron Systems CSX1000, CSX1200 manual Ipcp IP Address Pool Out of IP addresses

USER’S GUIDE

[IP] WAN (Direct Host) Interface <WAN interface name>, invalid associated LAN interface <LAN interface name>

The WAN (Direct Host) type interface could not come up; the associated LAN network interface, specified by configuration, was not found. Use CFGEDIT to delete old WAN (Direct Host) interface. Check for associated LAN interface, and add if necessary. Then add back the WAN (Direct Host) interface.

[IP] WAN (Direct Host) Interface for network <network #> on LAN port <port #> initialized successfully This message is posted when WAN (Direct Host) interface for the indicated network is initialized successfully.

[IPCP] Invalid pre-configured IP address <IP address> for <device name>, ignored

There is a configured IP address for the remote device in the Device Table, but the IP address does not belong to any configured WAN interfaces. Check the configuration. You will most likely need to add another WAN interface.

[IPCP] IP Address Pool - Out of IP addresses

IPCP needed to allocate an IP address from the IP address pool, but there were no IP addresses available in the IP address pool. You may need to add more IP addresses to the pool.

[IPCP] Option Negotiation Failure, Non-Convergence detected

IPCP is terminated because an agreement could not be reached on the details of protocol. Refer to the specific documentation for the device in question to determine if it is configured correctly. Then, contact your Distributor or Customer Support.

[IPCP] Remote device does not negotiate IP address

Please configure IP address for the device <device name>

The IP address for the remote device is either improperly configured, or not configured at all. Check configuration and adjust.

[IPFILT] Filter “abcd” does not exist, ignored by application point “xyz”

This particular error message detects that an attempt has been made to apply a non-existent filter. In theory, this can only happen if someone manually modifies a configuration file (other than through CFGEDIT or Manage Mode).

[IP Host] Call Dropped: ID Response was not received from remote

The system did not receive a valid identification exchange from the remote IP Host. The system has rejected the incoming call. Refer to the Quick Start for proper setup of your particular device.

[IP Host] Call Dropped: XID was not received from remote

The system did not receive a valid identification exchange from the remote IP Host. The system has rejected the incoming call. Refer to the Quick Start.

[IP Host] Security Rejection - Digit string wrong length

The system did not receive a valid identification exchange from the remote IP Host. The Identification digit string from the remote device was not of an appropriate length. This string must be a 24 character string of ASCII digits (0-9), which is blank padded. The system has rejected the incoming call.

456 CyberSWITCH