Cabletron Systems CSX1200, CSX1000 manual Appletalk Routing Initialization

PROBLEM DIAGNOSIS

AppleTalk Routing

ISDN

CSX1200

"Site1"

Net Range: 10-11

Zone: Left Zone

CSX1200

"Site2"

Net Range: 20-21

Zone: Right Zone

Local Mac Remote Mac

APPLETALK ROUTING INITIALIZATION

Problem:

The CyberSWITCH does not display the correct AppleTalk Routing Initialization messages.

Action:

1.Check the system configuration. Make sure that the AppleTalk feature is enabled for the system.

APPLETALK ROUTING OPERATIONAL OVER THE LAN CONNECTION

Problem:

No zones appear in the Mac’s Chooser.

Action:

1.Verify that the AppleTalk LAN port that Local Mac is attached to is in up state by entering the following console command:

atalk port

If the command shows the port is not in up state, wait for a couple of minutes and repeat this step.

2.Check to see if the LAN connection of the port is operational. If the LAN connection is not operational, then correct the problem.

3.If you are using Classic Networking, verify that EtherTalk is used on the Local Mac by opening the Network control panel as shown below:

Workgroup Remote Access Switch 405