Cabletron Systems CSX1000, CSX1200 manual X25 facilities warning, NUI not available

USER’S GUIDE

X25 facilities warning, NUI not available

Network device identification not available. No action required.

X25 permanent virtual circuit down: Access=<access index>, PVC=<PVC index>, LCN=<LCN>

The indicated X.25 virtual circuit is down. Switched backup connections will be used, if available. This message will occur if the other system is down, or if the network interface line is not connected, or if the authentication of the remote device failed.

X25 permanent virtual circuit to device <device name> up: Access=<access index>, PVC=<PVC index>, LCN=<LCN>

The indicated X.25 virtual circuit is operational.

XMODEM DATA FAILED CRC CHECKS

A file contained in the X-Modem file set has failed the CRC check. The system will automatically reset and attempt a reboot in an effort to correct the problem. If the system continues to fail, make note of the displayed messages, and call your distributor. A software update is likely needed.

Zone allocation failed, increase zone table capacity.

The number of AppleTalk zones has surpassed the configured zone table capacity. The CyberSWITCH configuration utility allows you to set the maximum number of defined and learned zone table entries. The default value is 512. The maximum is 2,000. You may need to reset the zone table capacity to a higher number.

Zone allocation failed, maximum capacity already configured

The maximum number of AppleTalk zones have been surpassed. Contact your Distributor or Customer Support.

486 CyberSWITCH