Cabletron Systems CSX1200, CSX1000 manual Tftp Commands, Tftp GET

SYSTEM COMMANDS

TFTP Commands

TFTP COMMANDS

The TFTP feature and its commands are only available when IP routing is enabled. The TFTP feature and file access are enabled by default when the system software is installed. Using the Manage Mode, configuration changes may be made that will limit file access. The following TFTP commands are available:

tftp get

Allows you to perform the “TFTP GET” operation locally from the console through the TFTP Client function. The following is an example display of a TFTP GET screen.

> TFTP GET

>IP Address of the Host containing the file (<RET> to abort)? 19.233.45.33

>Enter the name of the local file to write (including the full path)? (<RET> to abort)? \config\config.nei

>Enter the name of the remote file (including the full path) (<RET> for same as local)? <RET>

Enter the mode (BIN [binary] or ASC [ascii]) <RET> for ascii? bin

Receiving File... Please wait

File Transfer Complete...

tftp kill <session Id>

Allows you to kill a TFTP session. The session Id must be included in this command. To obtain the session Id, issue the tftp session command which displays the TFTP session information.

tftp put

Allows you to perform the TFTP PUT operation locally from the console through the TFTP Client function. The following is an example display of a TFTP PUT screen.

> TFTP PUT

>IP Address of the Host to receive the file (<RET> to abort)? 19.233.45.33

>Enter the name of the local file to send (including the full path) (<RET> to abort)? \config\config.nei

>Enter the name for the remote file (including the full path) (<RET> for same as local)? <RET>

Enter the mode (BIN [binary] or ASC [ascii]) <RET> for ascii? bin

Sending File... Please wait

File Transfer Complete...

tftp session

Displays the TFTP session information of active TFTP sessions. To get detailed information on a specific session, enter the session’s Id number when prompted. You can not display the

Workgroup Remote Access Switch 555