Cabletron Systems CSX1200 LAN Adapter out of receive buffers for the WAN port, LAN Adapter Reset

SYSTEM MESSAGES

System Message Summary

LAN Adapter out of receive buffers for the WAN port

The LAN adapter is temporarily out of the buffers it uses to receive packets from the WAN port. This condition should clear itself. If the condition persists, contact your Distributor or Customer Support.

LAN Adapter port <port #> transmit error <error code>, check connection

The LAN adapter detected an error transmitting a frame on the indicated port. Check that the LAN is properly connected to the adapter and that the LAN is properly terminated.

LAN Adapter Reset

This is an initialization message. The Ethernet adapter has been reset as part of the adapter initialization sequence.

LAN Adapter Response Timeout

The system expected a command response from the adapter that it did not receive. Check for proper hardware installation.

LAN Adapter ROM version #### #### .### #### # .# ##### ##

The ROM version in the Ethernet adapter is indicated.

LAN Adapter software version conflict

When software is downloaded onto the Ethernet adapter, its software version is compared to the version of software running on the host’s main processor. If the versions do not match, this message is posted. The upgrade did not work properly; contact your Distributor or Customer Support.

LAN Adapter System resource error

LAN Adapter hardware failure detected. If the problem persists, replace your LAN adapter.

LAN Init Error

LAN connection failure. Initialization failure detected by the LAN packet forwarding component in the system.

LAN Port <port #> detected a transceiver problem

The system detected a LAN connection problem on the indicated port. Check for proper LAN connection installation.

LAN Port <port #> detected jabber condition <n> times(s)

A “jabber” condition or an Ethernet frame larger than the maximum legal length has been received. This message is usually displayed if there is a malfunctioning transceiver or a malfunctioning Ethernet device on the LAN. This message is not displayed for every error condition. It appears after 24 hours since the last message was displayed. This message provides the LAN port # in question, and the number of times <n> the jabber condition has been detected.

LAN Port <port #> detected open LAN media

The system detected a problem with the physical LAN on the indicated port. The LAN is not properly terminated or the LAN is not fully connected to the system. Check for proper LAN installation.

Workgroup Remote Access Switch 461