USER’S GUIDE

BRIDGE FILTERS

CONFIGURING BRIDGE FILTERS

Note: Bridge dial out calls can be initiated through the use of a Known Connect list or through the use of bridge filters. For a description of bridge dial out through bridge filters, refer to the section titled Dial Out Using Bridge Filters.

USING CFGEDIT

1.Select Bridge Filters from the Bridging menu.

2.Configure any needed protocol definitions. These definitions will be used if you configure any protocol filters. To configure a protocol definition:

a.Select to add a protocol definition.

b.Enter a user-defined name for the protocol definition.

c.Enter the Ethernet type in hex.

d.Enter the LSAP in hex.

3.Configure source MAC filters.

a.Select to add a MAC filter.

b.Enter the source MAC address.

c.Select a distribution list.

3.Configure destination MAC filters.

a.Select to add a destination MAC filter.

b.Enter the destination MAC address.

c.Select a distribution list.

5.Configure protocol filters.

a.Select to add a protocol filter.

b.Select a protocol definition Id.

c.Select a distribution list.

6.Configure packet data filters.

a.Select to add a packet data filter.

b.Enter the off set value.

c.Enter the mask in hex.

d.Enter the data value in hex.

e.Select a distribution list.

USING MANAGE MODE COMMANDS

Manage Mode can be used to complete all of the bridge filter configuration. This section provides you with the commands available for each bridge filter type.

222 CyberSWITCH

Page 222
Image 222
Cabletron Systems CSX1000, CSX1200 manual Configuring Bridge Filters Using Cfgedit