Cabletron Systems CSX1200, CSX1000 manual IPX-Specific Information for Devices

CONFIGURING IPX

IPX-Specific Information for Devices

4.Press 1 to add a device.

5.Enter the device’s name and press <RET>. You should provide ISDN and Authentication information first.

6.Select IPX. A screen similar to the following will be displayed:

Device IPX Configuration Menu: (Device = "remote1")

1)	IPX Routing	DISABLED
2)	Make calls for IPX data	DISABLED
3)	IPXWAN Protocol	DISABLED
4)	Routing Protocol	NONE

5)Spoofing Options

Select function from above or <RET> for previous menu:

7.Enable IPX routing. Select IPX Routing and follow on-screen instructions.

8.Enable make calls feature. Select Make calls for IPX data and follow on-screen instructions only if the CyberSWITCH is to dial-out to remote1.

9.Although IPXWAN Protocol appears on the menu, the feature is not yet completely functional.

10.Select Routing Protocol. A menu similar to the following will be displayed:

IPX Device Routing Protocol Menu:

1)None

2)RIP/SAP

3)Triggered RIP/SAP

Enter selection or press <RET> for previous menu [default=None}:3

1)ACTIVE

2)PASSIVE

Triggered RIP/SAP WAN Peer type [default=ACTIVE]: 1

11.Select routing protocol. When you select Triggered RIP/SAP, you will need to identify the WAN peer type as either active or passive. An active peer receives broadcasts at all times; a passive peer receives broadcasts only when a connection is up.

12.Select Spoofing Options. Make changes to default spoofing setup, if desired, through the following menu:

IPX Device Spoofing Menu:

1)IPX Watchdog Spoofing

2)SPX Watchdog Spoofing

3)Serialization Packet Handling

4)Message Packet Handling

Select function from above or <RET> for previous menu: 1

a.Press 1 to configure IPX watchdog spoofing. The following menu will be displayed:

Workgroup Remote Access Switch 293