Cabletron Systems CSX1200 IPX RIP Shutdown complete, IPX RIP Space available in routing table

SYSTEM MESSAGES

System Message Summary

[IPX RIP] Shutdown complete.

The IPX RIP protocol was successfully shutdown via Dynamic Management. No IPX RIP routing information will be transmitted or received. Any routes learned via IPX RIP will soon expire.

[IPX RIP] Space available in routing table

A route entry has become available in the full route table.

[IPX RIP] Unable to add route, routing table full

The route table has become full. The maximum number of route entries should be increased. Note: This message will not recur in the log until space becomes available in the route table.

[IPX SAP] Buffers allocated

The IPX SAP successfully allocated the buffers needed to transmit IPX SAP packets.

[IPX SAP] SAP Protocol Initialization successful The IPX SAP protocol was successfully initialized.

[IPX SAP] Shutdown complete

The IPX SAP protocol was successfully shutdown via Dynamic Management. No IPX SAP service information will be transmitted or received. Any services learned via IPX SAP will soon expire.

[IPX SAP] Space available in service table

A service entry has become available in the full service table.

[IPX SAP] Unable to add service, service table full

The service table has become full. The maximum number of service entries should be increased. Note: This message will not recur in the log until space becomes available in the service table.

[IPXCP] Add Network Address to Pool with value above <network address>

This message informs the administrator that negotiation was not possible since non-convergence was detected the network address sent by the peer was not acceptable by us and we do not have any network address to assign to the peer. The possible remedy is to configure more IPX addresses with a value more than <Network Address> in the Address Pool.

[IPXCP] IPX Address Match.

[IPXCP] Device <device> address same as another device address

The remote device indicated by <device> requested to use an already existing IPX network number and node number.

[IPXCP] Our Node Address is <node address>

This message informs the administrator that the peer has assigned us a node number because the system did not have a node address and the peer needs a node address. This node address will be used by the peer to identify this system.

[IPXWAN] Master Slave Conflict. Change Internal Network Number above <present value>

This message indicates that over the IPXWAN link, the master and slave roles could not be determined. The internal network number of the system must be changed to ensure proper IPXWAN negotiation to occur.

[IPXWAN] IPX Internal Network Number must be configured.

You must configure a valid internal network number in order for IPX routing to work properly.

Workgroup Remote Access Switch 459