SYSTEM MESSAGES

System Message Summary

Error mapping WAN adapter #’x’ into Host memory map

The configured memory location of the indicated WAN card conflicts with another WAN card or device. Review the configuration for the indicated adapter.

Error opening file <file name>

Error opening file <file name>, section = <section name>

Error opening file <file name>, slot <slot #>

If seen repeatedly, contact your Distributor or Customer Support.

Error parsing old WAN (Direct Host) interface: bad format

The information contained in the WAN (Direct Host) interface is invalid. To correct, use CFGEDIT to reconfigure the interface.

Error initializing WAN card: <WAN card Id>

The system could not initialize the specified WAN card during system initialization. Check the WAN card installation and configuration. If the error continues, report the problem.

Error parsing old WAN (Direct Host) interface: LAN interface <LAN netif name> for specified port <port#> already in use

This error may display after upgrading software which contains secondary IP addressing and an “old” style WAN (Direct Host) interface. To correct, use CFGEDIT to delete any WAN (Direct Host) interfaces on the problematic LAN port, and reconfigure them.

Error parsing old WAN (Direct Host) interface: no LAN interface for specified port <port#>

This error may display after upgrading software which contains secondary IP addressing and an “old” style WAN (Direct Host) interface. To correct, use CFGEDIT to delete the problematic WAN (Direct Host) interface. Afterwards, configure a LAN interface and then read the WAN (Direct Host) interface.

Error parsing WAN (Direct Host) interface: no LAN interface for specified name <name>

The LAN network interface associated with this WAN (Direct Host) interface is not present. Use CFGEDIT to delete the problematic WAN (Direct Host). Check configuration for the suspect LAN interface; it most likely will not be there. Add LAN interface, then reconfigure the WAN (Direct Host) interface.

Error opening file \system\ethernt2.bin

The LAN adapter executable file could not be opened. Check for proper software installation.

Error programming adapter #’x’ hardware

The WAN card initialization subsystem encountered an error while attempting to program the hardware on the indicated adapter. Restart the system and review the configuration for the adapter. If the problem persists, the indicated adapter card may be faulty; contact your Distributor or Customer Support.

Error reading file <file name>, section = <section name>

If seen repeatedly, the above message indicates a problem with your file system. Contact your Distributor or Customer Support.

Error reading file \system\ethernet2.bin,section = <file type>

The specified section of the LAN adapter executable file could not be read. Check for proper software installation.

Workgroup Remote Access Switch 447

Page 447
Image 447
Cabletron Systems CSX1200 Error mapping WAN adapter #’x’ into Host memory map, Error opening file \system\ethernt2.bin