Cabletron Systems CSX1000, CSX1200 CSX1001, shown below, is equivalent to the NE Link 1000 B2

USER’S GUIDE

The CSX1001, shown below, is equivalent to the NE Link 1000 B2.

WORKGROUP REMOTE ACCESS SWITCH

LAN

POWER SERVICE TX RX 10BASE-T

LINE

1

CH-1CH-2

SYNC D-CH

AGI

! CAUTION

FOR CONTINUED PROTECTION

AGAINST RISK OF FIRE,

REPLACE

ONLY WITH SAME TYPE AND

RATING OF FUSE.

BRI (Termination switches behind plate; see diagram

INPUT

85-250V 47-63 - 1.6A MAX

AUI 10Base-T CONSOLE FUSE TYPE: IEC 127/ III RATED F1.6AL-250V

The CSX1001

PLATFORM DESCRIPTION

The NE Link 1000 and CSX1000 platforms consists of two processors (the 80386 EX and the 80960 SA), system memory, and interface adapters. The front of the platforms have a series of LED indicators. These indicators light up to indicate power, service, LAN access, and WAN access. On the back of the platform is the ON/OFF switch, connectors for power, the LAN, the WAN, and an administration port for local or remote administration console attachment. There is a fan housed in the rear of the platform, as well as side venting on the unit.

The front panel has a series of indicators. The POWER indicator will remain lit while the unit is on. There are also LAN, WAN, and service indicators. For a more detailed description of each LED indicator, refer to LED Indicators.

The unit’s ON/OFF switch is located in the upper right corner of the back panel. Directly below this switch are the AC power input and fuse box. Note that the unit requires a 250V, 5 x 20 mm time- lag fuse rated at 1.6 amps. The back panel also provides connectors for WAN and LAN access, as well an RS232 port for an administration console. The RS232 port is also available for PPP-Async data transfer. The fan grill on the back panel, as well as the venting on the side panel, should not be obstructed.

38 CyberSWITCH