Cabletron Systems CSX1000, CSX1200 manual IPX Routing Commands

USER’S GUIDE

ip stats

Displays the current IP related statistics. Refer to IP Statistics, for a list of available statistics and their definitions.

IPX ROUTING COMMANDS

IPX routing must be enabled before these commands can be used.

The following commands are used to display IPX routing information:

ipx ipxwan clear

Clears IPXWAN statistics.

ipx ipxwan stats (device)

Displays system-level IPXWAN statistics when device name not specified:

IPXWAN Statistics
Timer Request	=	Timer Response	=
Information Request	=	Information Response	=
Thruput Request	=	Thruput Response	=
Delay Request	=	Delay Response	=
NACK Sent	=	NACK Received	=
Bad Packets	=

Displays Negotiation Parameters when device name specified and connected:

WAN Statistics for device “xxxx”

Negotiation Parameters:

IPX	Network Address =	IPX Node	Number =
Telebit Compression =		Protocol	=
WAN	Link Delay =

ipx diag <host ipx address> [timeout]

Tests device connectivity to specified IPX host by sending out a diag packet. If connection is up, host sends a message in response to this packet to confirm receipt. The parameters for this command are:

host ipx address

IPX address for the host, in <network number>:<node number> format. The network number is a hexadecimal number up to eight digits in length. The node number is the host’s MAC address. For example, if the assigned network number of “AAAA,” and the host has a MAC address of 40AA68965439. For this example, you would enter “AAAA:40AA68965439” for the host IPX address.

timeout

Optional parameter that indicates the number of seconds to wait for a reply. The valid range for the time out value is 1 to 60 seconds. The default value is 10.

542 CyberSWITCH