Cabletron Systems CSX1000 RBS Unexpected event chan = channel #, state = state ID, Rebooting

USER’S GUIDE

system to start dialing. Contact the telephone company and ensure that the line is configured for wink-start.

RBS: Unexpected event chan = <channel #>, state = <state ID>

An illegal signaling event occurred in the RBS task on the specified channel. Ensure that the line is configured correctly and that it is using the expected RBS protocol. Excess noise on the line may also cause this event.

Read 0 bytes from file <file name> for WAN card in slot <slot #>

If seen repeatedly, the above message indicates a problem with your hard drive. Contact your Distributor or Customer Support.

Ready for XModem Download - <ESC> to abort

The user has requested an attempt to UPDATE the system software, or it was not possible to Boot the system the last time it was attempted.

Reattempting to Install File Set into Flash Memory

The SSB is re-attempting to install the FileSet. The Flash File System may have been corrupted when attempting to install the FileSet the first time. In the meantime, the Flash File System has been formatted.

Rebooting...

The system is going to wait until the WatchDog timer expires, which causes the entire system to reboot.

Received charge amount - <charge amount>

The system has received an advice of charge from the network for the call just disconnected. The charge for this call is indicated in the charge amount parameter.

Received CLLM while PVC for DLCI <dlci index> in unexpected state <state>

A CLLM message was received indicating that a network condition should be expected for the PVC associated with the indicated DLCI. However, this PVC is in the indicated state and as such is already acting on a previous network condition notification.

Remote peer ID discrepancy

The On-node Device Table and the remote end of the connection disagree on the identity of the remote end. Check configuration, and then reboot the remote device. If problem persists, contact your Distributor or Customer Support.

Replace Lithium Battery: Contact your Representative

If this message is displayed in the log messages, contact your Distributor or Customer Support before you power off your system.

Requested channel not available - <slot #, port # >

The system has attempted a call using a channel on the indicated line that was not available. The call will be retried over a different line if possible.

Reserved signal

This message is informational only and is used to indicate additional details on the <signal value> received in the “call progress” information message.

470 CyberSWITCH