Cabletron Systems CSX1000, CSX1200 manual DM card in slot slot # is not functional

USER’S GUIDE

DM card in slot <slot #> is not functional

The system was unable to initialize the Digital Modem in the specified slot correctly. Check all switch and/or jumper settings on the board to ensure they match the values in CFGEDIT. If the board is configured properly, and this message still appears, contact your Distributor or Customer Support.

DM card in slot <slot #> will receive new firmware

Informational message stating that the system has detected that the current firmware of the specified modem is a lower revision level than what is supported in the currently installed software. For 56K modem technology, the system will attempt to update the card. For modem technology other than 56K, the upgrade command must be used to upgrade the firmware revision. Watch for subsequent log messages to ensure the update is successful.

DM card in slot <slot #> failed FLASH download

The system has failed to successfully update the firmware revision of the Digital Modem card. Contact your Distributor or Customer Support.

DM card in slot <slot #> FLASH download complete

Informational message stating that the system has successfully updated the firmware present on the Digital Modem card.

DM card in slot <slot #> signals it is operational

Informational message stating that the Digital Modem is now ready for use.

DM card type configured in slot <slot #> does not exist

Using the resource database, the system has tried to initialize a Digital Modem card that doesn’t exist. Check all switch and/or jumper settings on the board to ensure they match the values in CFGEDIT. If the board is configured properly, and the message still appears, contact your Distributor or Customer Support.

DM card in slot <slot #> will not come out of reset

There are problems initializing the board. Contact your Distributor or Customer Support.

DM upgrade timeout. Board=<board #>, Modem=<modem #>

DM upgrade error during download. Modem says = xxx

DM upgrade no response at start. Board=<board #>, Modem=<modem # >

DM upgrade flash erase failed. Board=<board # >, Modem=<modem #>

DM upgrade no response at end. Board=<board #>, Modem=<modem #>

There were problems while attempting to update the firmware of the specified modem due to either a corrupt firmware file or hardware problems. Reseat the card in its ISA slot, and/or check the MVIP cabling. If problems persist, contact your Distributor or Customer Support.

DM upgrade started. Board=<board #>, Modem=<modem #>

The system has begun to update the firmware of the specified modem on the Digital Modem card. Watch for subsequent log messages to ensure the update is successful.

DM session in unknown upgrade state. Board=<board #>, Modem=<modem # >

There were problems while attempting to update the firmware of the specified modem due to either a corrupt firmware file or hardware problems. Contact your Distributor or Customer Support.

444 CyberSWITCH