Cabletron Systems CSX1000, CSX1200 Specify a control value any, established, or not established

USER’S GUIDE

CONFIGURING TCP

If you have selected TCP as your IP protocol, a screen similar to the following is displayed. Note that the following TCP defaults constitute a wild card match for any TCP packet:

PACKET		TYPE "Type_One":
1)	IP Source Address		AND 0.0.0.0 EQUAL 0.0.0.0
2)	IP Destination Address		AND 0.0.0.0 EQUAL 0.0.0.0
3)	IP Protocol		EQUAL TCP
4)	TCP	Source Port	RANGE 0	- 65535
5)	TCP	Destination Port	RANGE 0	- 65535
6)	TCP	Control	ANY

Select function from above or <RET> for previous menu:

1.Select TCP Source Port. Note that the ports are specified in terms of an operator.

2.Select a comparison operator.

3.If you have chosen the comparison operator of “RANGE”, you will be prompted for upper-range and lower-range values. If you have chosen a comparison operator other than “RANGE”, you will be prompted for a specific TCP port number.

4.Select TCP Destination Port. Note that the ports are specified in terms of an operator.

5.Select a comparison operator.

6.If you have chosen the comparison operator of “RANGE”, you will be prompted for upper-range and lower-range values. If you have chosen a comparison operator other than “RANGE”, you will be prompted for a specific TCP port number.

7.Select TCP Control.

8.Specify a control value (any, established, or not established).

CONFIGURING UDP

If you have selected UDP as your IP protocol, a screen similar to the following is displayed. Note that the following UDP defaults constitute a wild card match for any UDP packet:

PACKET TYPE "Type_One":
1)	IP Source Address	AND 0.0.0.0		EQUAL 0.0.0.0
2)	IP Destination Address	AND 0.0.0.0		EQUAL 0.0.0.0
3)	IP Protocol	EQUAL UDP
4)	UDP Source Port	RANGE 0	- 65535
5)	UDP Destination Port	RANGE 0	- 65535
Id of the item to change, <RET> to accept				changes or <CTRL-C> to cancel

1.Select UDP Source Port. Note that the ports are specified in terms of an operator.

2.Select a comparison operator.

244 CyberSWITCH