Appletalk Capacities

CONFIGURING APPLETALK ROUTING

AppleTalk Capacities

APPLETALK ROUTING STATIC ROUTES CONFIGURATION ELEMENTS

APPLETALK NETWORK TYPE

The AppleTalk network type used by the destination network of this static route. Type can be either Extended Network or NonExtended Network.

DESTINATION NETWORK RANGE/NUMBER

The remote AppleTalk network range (for Extended network) or network number (for NonExtended network) reachable through this static route entry.

NEXT HOP DEVICE

The AppleTalk address of the next hop device that provides access to the destination AppleTalk network. If the next hop is over an unnumbered WAN link, then the device name is specified. The name must be a valid Device table entry.

NUMBER OF HOPS

The number of AppleTalk routers that are traversed in order to reach the destination AppleTalk network.

ZONE NAME(S)

The name of the zone(s) on the remote AppleTalk network.

APPLETALK ROUTING STATIC ROUTES BACKGROUND INFORMATION

You only need to configure static routing entries if you need to access a WAN network that is not directly connected to the system, or if you need to access a LAN network through a router that does not support AppleTalk RTMP. Static routes specify the AppleTalk address of the next hop router that provides access to this network.

CONFIGURING APPLETALK CAPACITIES

USING CFGEDIT

1.Select AppleTalk Capacities from the AppleTalk Routing Menu.

2.Press 1 to set the maximum number of entries for the AppleTalk Route table.

3.Press 2 to set the maximum number of entries for the AppleTalk zone table.