USER’S GUIDE

[STP] A BLAN Topology Change has been detected

The system has detected a topology change in the Spanning Tree environment.

[STP] A new Root Bridge has been detected

The system has detected a new root bridge for the Spanning Tree environment.

[STP] LAN Port <port # > is now a Designated Port

The indicated LAN port has become the designated port for the attached LAN.

[STP] LAN Port <port # > is now the Root Port

The indicated LAN port has become the root port for the system.

[STP] This Bridge is now the Root Bridge

The system has become the root bridge for the Spanning Tree environment.

Successfully Loaded Release <X.Y> Issue <Z>

The specified release of System software was successfully loaded into memory.

Switch could not recognize phone number nnnnnnn

The switch did not accept the phone number dialed as a complete number. Check the correctness of the phone number (including any leading digits such as 8 or 9).

System Clock Fault on Wan Adapter in Slot <slot #>

Indicates a TDM bus connection failure. Check to make sure that the TDM bus has been correctly connected.

TACACS authentication is not available. You must first ENABLE TACACS user level authentication. An attempt was made to configure the Terminal Server Security for TACACS and TACACS was not configured on the CyberSWITCH.

TCP Connection to VRA Manager Lost

The TCP connection to the SFVRA Connection Manager has gone down.

TDM Clock Master changed TO (slot #, port#) FROM (slot # , port # )

The Clock Manager has dynamically adjusted the master clock source in response to an external line state change.

Temporarily unable to read flash file system due to flash reclaim in progress - try again later

The system is automatically performing a flash reclaim to reclaim space previously occupied by deleted files. Wait several seconds (up to a minute maximum) and try your file system command again.

Terminal Server Security connections disabled. Dropping call.

The Terminal Server Security is set to none and a terminal connection was requested. Check configuration. Most likely, the Default Async Protocol is set to terminal with no Terminal Server Security configured.

Terminal Server Security is currently using this database. You must change the Terminal Server Security setting first.

An attempt was made to disable a User Level Security Database when the terminal server was configured to use this database for terminal mode authentication.

476 CyberSWITCH

Page 476
Image 476
Cabletron Systems CSX1000, CSX1200 STP a Blan Topology Change has been detected, STP a new Root Bridge has been detected