Cabletron Systems CSX1200, CSX1000 manual DM upgrade success. Board=board #, Modem=modem #

SYSTEM MESSAGES

System Message Summary

DM upgrade success. Board=<board #>, Modem=<modem #>

The system has successfully updated the firmware of the specified modem on the Digital Modem card.

DM: TimeSlot driver circuit id already in use on CREATE

DM: No TimeSlot driver circuits available for CREATE

DM: TimeSlot driver circuit id not in use on REMOVE

DM: TimeSlot driver circuit id not found on REMOVE

There were problems related to the Digital Modem’s use of the TDM bus. Contact your Distributor or Customer Support.

Downloading Bootstrap to DM card in slot <slot #>

Informational message stating that the system is attempting to initialize a Digital Modem card. Watch for subsequent log messages to ensure the initialization is successful.

Downloading DM card in slot <slot #> with operational software

Informational message displayed during a successful initialization. Watch for subsequent log messages to ensure the initialization is successful.

Downloading WAN card in slot <slot #> with operational software

Informational message during a successful system initialization. The status of the download process for WAN card in slot <slot #> is identified. This should be reported after the “Bootstrap came alive...” message for a given adapter.

DSL test failed to establish Layer 1, port=<port #>

During power up, all WAN lines undergo a test to see if Layer 1 can be established. This message indicates a test failure. Check the wiring. If correct, contact your phone company.

Duplicate Calling Line ID <Calling line Id> detected for devices <device name> and <device name>

This message is logged at system initialization if any devices are found to share duplicate Calling line Ids, and have no other authentication method. This problem should be corrected by adding additional authentication method(s) to the necessary device(s).

Each mandatory connection uses xx bytes

There is not enough memory available to accommodate the system’s total capacity load. This informational message identifies how much memory is needed to add an additional mandatory connection.

Each optional connection uses xx bytes

There is not enough memory available to accommodate the system’s total capacity load. This informational message identifies how much memory is needed to add an additional optional connection.

ECP negotiation failed to converge

Verify compatible encryption parameters on each side of the link.

EDRV transmit error <error code>

An error was returned upon the software’s request to transmit a data frame. Contact your Distributor or Customer Support.

Workgroup Remote Access Switch 445