Cabletron Systems CSX1000, CSX1200 manual Clears all statistics associated with the fr stat command

USER’S GUIDE

Note that this command may be used in conjunction with all other fr commands. For example, fr a 1 lmi would be a valid command, changing the frame relay access to 1 before displaying information relating to the LMI link.

fr d <DLCI m>

Sets an internal variable. <DLCI m> will be the default DLCI under the currently-selected access, and therefore the assumed context for all subsequent frame relay system console commands entered. <DLCI m> will remain the default DLCI until the default is changed through reissuing the fr d <DLCI m> command. The DLCI value is provided by the service provider at line subscription time.

For the following frame relay commands, information is displayed for the currently selected access. However, you may also change the access (which, in turn, changes the default) by using these commands along with the access index command. Refer to the fr a <access n> command.

fr display

Displays the configuration information as entered during the last CFGEDIT session for the currently-selected frame relay access. Note that this also includes any configured PVCs associated with this access.

fr stats

Displays the statistics associated with the currently-selected access and DLCI. Refer to Frame Relay Statistics, for a list of available statistics and their definitions.

fr clear

Clears the statistics counters associated with the fr stat command for the currently selected access and DLCI.

fr clearall

Clears all statistics associated with the fr stat command.

fr lmi

Displays information relating to the LMI link on the currently-selected frame relay access, if that access has the layer Management Interface enabled. The following list describes the fields displayed when the FR LMI command is entered.

LMI State

The condition of the LMI link. Possible settings for this item are WAIT FULL STATUS (S1), WAIT T391 TIMEOUT (S2), and WAIT LIV STATUS (S3). The possible settings are defined as follows:

WAIT FULL STATUS

The LMI state entered when the local frame relay software has transmitted a STATUS ENQUIRY message requesting a FULL REPORT STATUS message.

WAIT T391 TIMEOUT

The LMI state entered when the local frame relay software has received a STATUS message from the network in response to a previous STATUS ENQUIRY and has restarted the T391 timer. (The T391 parameter is the configured Link Integrity Verification Timer.)

WAIT LIV STATUS

The LMI state entered when the local frame relay software has transmitted a STATUS ENQUIRY message requesting a LINK INTEGRITY VERIFICATION STATUS message.

536 CyberSWITCH