Cabletron Systems CSX1000, CSX1200 manual All packets will be captured

USER’S GUIDE

pkt capture [all/idle/reqd/pend/actv/none]

Specifies which packets will be captured by the Packet Capture feature. A definition of each possible parameter follows.

all

All packets will be captured.

none

No packets will be captured.

reqd

Only packets causing a connection to be requested will be captured.

pend

Only packets received while a requested connection is pending will be captured.

idle

Only packets not causing a connection to be requested will be captured. This could be caused by the destination site not being in the Initiate Connection List, or by the route not being in the IP Routing Table.

The pkt capture command allows multiple connection modes to be specified on a single command line. For example, the command:

pkt capture reqd pend

captures only packets that cause a connection to be requested and packets that were received before the connection became active.

pkt load <filename>

Loads previously saved Packet Capture file into memory.

pkt save <filename>

Saves captured packets to a disk file. Full path names are allowed, for example: A:MYPKT.DAT.

pkt display

Displays captured packets that have been collected via pkt on or via pkt load. Note that this command is not supported for a Telnet session.

546 CyberSWITCH