Fujitsu P50XTA51E SERIES Other Settings, E-27, Auto Off-NO SIG, Español Deutsch, Audio Input

OTHER SETTINGS

English

Auto Off-NO SIG.

You can make to the standby state automatically when the no signal state continued during set up time. Press CDto select the “Time”.

Press EFto select the amount of time before the standby state starts.

Off 1 min. 15 min. 45 min. 60 min. 

Press <to store.

*The numerical value is the approximate amount of time before the standby state starts. You can assign the black or white color for the background color at the no signal state. Press CDto select the “Background”.

Press EFto select the displayed background displayed.

Black White

“Auto Off-NO SIG.” selection screen

Español Deutsch

Press <to store.

* The background color changes to assigned color state after approximate 20 seconds at the no signal state.

Français

Audio Input

You can use this option to select the available terminals to receive the audio from input equipment.

(1)Select “Audio Input” and press <.

The “Audio Input” setting screen will appear.

(2)Press Cor Dto select video input terminal.

(3)Select a related audio input terminal.

Each time you press Eor F, one of the available choices appears in the following sequence:

No Audio Audio1 Audio2 • • • • • 

[No Audio]: No audio in the corresponding mode.

[Audio 1-4]: Selects Audio 1 through 4 for receiving audio in the corresponding mode.

[Audio 5-6]: HDMI

*There is also “Audio Input” that cannot be selected.

*Repeat steps (2) and (3) for each piece of input equipment.

(4)Press <to store.

*AUDIO menu will not be displayed when “No Audio” is selected.

Screen Orbiter for RGB

You can use this option to move the screen position to minimize phosphor-induced “burn-in”. Follow the steps below.

(1)Select “Screen Orbiter” and press <.

The “Screen Orbiter” setting screen will appear.

(2)Press Cor Dto select “Mode/Time”.

(3)Select a desired pattern.

Each time you press Eor F, one of the available choices appears in the following sequence:

Off Time Mode

[Off]: Disables Screen Orbiter.

[Time]: Moves the pattern approximately every one hour.

[Mode]: Moves the pattern when the power is turned ON or when you switch between modes.

(4)Press Cor Dto select “Moving Area”.

(5)Press Eor Fto select the range for moving the pattern.

Each time you press Eor F, one of the available choices appears in the following sequence:

Min. Std. Max.

“Audio Input” setting screen

“Screen Orbiter” setting screen

Póññêèé Português Italiano

中文

[Min.]: Pattern moves in small range. (About 5 pixels)

[Std.]: Pattern moves in moderate range. (About 10 pixels)

[Max.]: Pattern moves in wide range. (About 15 pixels)

日 本 語

Downloaded From TV-Manual.com Manuals E-27