Cleaning the Inside of the ScanSnap
437
How to perform cleaning
1. Clean the following locations:
zBrake roller
zIdler roller
zGlass
zPick roller
zUltrasonic sensor
1. Unplug the cables from the ScanSnap.
2. Pull the ADF release tab to open the ADF top section.
3. Clean the following locations with a cloth moistened with Cleaner F1.
ATTENTION
zDo not use water or mild detergent to clean the inside of the ScanSnap.
zIt may take a long time for Cleaner F1 to dry if an excessive amount is used. Moisten the cloth
with a moderate quantity.
Wipe off the cleaner completely to leave no residue on the cleaned parts.
zBe careful when cleaning not to catch the cloth in the document detection sensor.
ADF release tab
ADF top section
ADF paper chute
(cover)
Document detection
center