Fig. 1 Indoor Unit
1Operating Control Panel (Fig. 2)
2 MANUAL AUTO button
3Remote Control Signal Receiver
4Indicator Lights (Fig. 3)
5OPERATION Indicator Light (red)
6 TIMER Indicator Light (green)
7 SWING Indicator Light (orange)
(VERTICAL SWING)
8 SWING Indicator Light (orange)
(HORIZONTAL SWING)
●If the TIMER indicator light flashes when the timer is operating, it indicates that a fault has occurred with the timer setting (See page 15 Auto Restart).
9Intake Grille (Fig. 4)
0 Air Filter
A UP/DOWN Air Direction Flaps
B RIGHT/LEFT Air Direction Louvers (behind UP/DOWN Air Direction Flaps)
C Drain Hose
D Air Cleaning Filter (optional)
Fig. 5 Outdoor Unit
EIntake Side F Outlet Side
Fig. 6 Remote Control Unit
GSLEEP Button
HMASTER CONTROL Button
ISET TEMP./SET TIME Buttons (
) J Signal Transmitter
K TIMER Button
L FAN CONTROL Button M START/STOP Button
N Battery compartment lid
Inside of the battery compartment lid (Fig. 7)
OAIR FLOW DIRECTION Button P ENERGY SAVE Button
Q CODE CHANGE (Slide Switch)
Switching the remote control unit code. (Max. 4 units)
R TIME ADJUST Button S TEST RUN Button
●This button is used when installing the air conditioner and should not be used under normal conditions as it will cause the air conditioner’s thermostat function to oper- ate incorrectly.
●If this button is pressed during normal op- eration, the unit will switch to test opera- tion mode, and the indoor unit’s OPERA- TION indicator light and TIMER indicator light will begin to flash simultaneously.
●To stop the test operation mode, either press the TEST RUN button once again, or press the START/STOP button to stop the air conditioner.
TACL Button
URemote Control Unit Display (Fig. 8) V Transmit Indicator
W Clock Display
X Operating Mode Display Y Timer Mode Display
Z Fan Speed Display
[ Temperature Set Display \ Timer Set Indicator
] Temperature Set Indicator
