Fujitsu ASU18T Cleaning And Care, En-20, Cleaning the Intake Grille, Remove the intake grille

Models: ASU18T Room Air Conditioner Multi Split Type (3 rooms) AOU36T

1 25
Download 25 pages 29.14 Kb
Page 21
Image 21
CLEANING AND CARE

CLEANING AND CARE

CAUTION!

Before cleaning the air conditioner, be sure to turn it off and disconnect the power supply.

● Be sure the intake grille is installed securely.

● When removing and replacing the air filters, be sure not to touch the heat exchanger, as per- sonal injury may result.

● Turn off the circuit breaker.

Cleaning the Intake Grille

1.Remove the intake grille.

1 Place your fingers at both lower ends of the grille panel, and lift forward; if the intake grille seems to catch partway through its movement, continue lifting upward to remove.

Intake Grille

2 Lift up the intake grille fully to remove.

2. Clean with water.

Remove dust with a vacuum cleaner; wipe the unit with warm water, then dry with a clean, soft cloth.

3.Replace the intake grille.

1 Holding the intake grille horizontally, fasten the two upper hooks on the unit.

Intake Grille

2Press the intake grille down at the lower sides to close.

Cleaning the Air Filter

1. Open the intake grille, and remove the air filter.

Lift up the air filter’s handle, disconnect the two lower tabs, and pull out.

Air filter handle

Hooks (two places)

2. Remove dust with a vacuum cleaner or by washing.

After washing, allow to dry thoroughly in a shady place.

3.Replace the air filter and close the intake grille.

1 Align the sides of the air filter with the panel, and push in fully, making sure the two lower tabs are returned properly to their openings in the panel.

Hooks (two places)

2 Close the intake grille.

(In the illustration, the unit is shown without the intake grille installed.)

Dust can be cleaned from the air filter either with a vacuum cleaner, or by washing the filter in a solution of mild de- tergent and warm water. If you wash the filter, be sure to allow it to dry thoroughly in a shady place before rein- stalling.

If dirt is allowed to accumulate on the air filter, air flow will be reduced, lowering operating efficiency and increas- ing noise.

During periods of normal use, the air filters should be cleaned every two weeks.

When using the optional Air Cleaning Filter

Install the optional air cleaning filter set as instructed (installation instructions are furnished with the air cleaning filter set).

When used for extended periods, the unit may accumulate dirt inside, reducing its performance. We recommend that the unit be inspected regularly, in addition to your own cleaning and care. For more information, consult authorized service personnel.

When cleaning the unit’s body, do not use water hotter than 100 °F, harsh abrasive cleansers, or volatile agents like benzene or thinner.

Do not expose the unit body to liquid insecticides or hairsprays.

When shutting down the unit for one month or more, first allow the fan mode to operate continuously for about one-half day to allow internal parts to dry thoroughly.

En-20

Page 21
Image 21
Fujitsu ASU18T, AOU36T Cleaning And Care, En-20, Cleaning the Intake Grille, Remove the intake grille, Clean with water