Fujitsu Room Air Conditioner Multi Split Type (3 rooms) Preparation, En-7, Turn on the Power

PREPARATION

Turn on the Power

In the case of a direct line connection, turn on the circuit breaker.

Load Batteries (AAA ⋅ 2)

1Press and slide the battery compartment lid on the re- verse side to open it.

Slide in the direction of the arrow while pressing the mark.

2	Insert batteries.
	Be sure to align the battery polarities (	) correctly.

3Close the battery compartment lid.

Set the Current time

1	Press the TIME ADJUST button (Fig. 7 S).
	Use the tip of a ball-point pen or other small object to press the button.

2Use the SET TEMP./SET TIME buttons (Fig. 6 L) to adjust the clock to the current time.

button: Press to advance the time.

button: Press to reverse the time.

	(Each time the buttons are pressed, the time will be advanced/reversed in
	one-minute increments; hold the buttons depressed to change the time
	quickly in ten-minute steps.)
3	Press the TIME ADJUST button again.
	This completes the time setting and starts the clock.

CAUTION!

●Take care to prevent infants from acciden- tally swallowing batteries.

●When not using the remote control unit for an extended period, remove the bat- teries to avoid possible leakage and dam- age to the unit.

●If leaking battery fluid comes in contact with your skin, eyes, or mouth, immedi- ately wash with copious amounts of wa- ter, and consult your physician.

●Dead batteries should be removed quickly and disposed of properly, either by plac- ing in a public battery collection recepta- cle, or by returning to appropriate author- ity.

●Do not attempt to recharge dry batteries.

Never mix new and used batteries, or batteries of different types.

Batteries should last about one year under normal use. If the remote control unit’s operating range becomes appre- ciably reduced, replace the batteries and press the ACL button (Fig. 7 T) with the tip of a ballpoint pen or other small object.

To Use the Remote Control Unit

●The remote control unit must be pointed at signal receiver (Fig. 1 3) to operate correctly.

●Operating range: About 7 meters.

●When a signal is properly received by the air conditioner, a beep be heard.

●If no beep is heard, press the remote control unit button again.

Remote Control Unit Holder

Insert

		Slide up
	Press in
Screws		Pull out
1 Mount the Holder.	2 Set the Remote Control	3 To remove the Remote
	Unit.	Control Unit .

En-7