SWING OPERATION
Begin air conditioner operation before performing this procedure.
To select SWING Operation
Press the SWING LOUVER button (Fig. 6 R).
The SWING indicator lamp (orange) (Fig. 3 7) will light.
In this mode, the Air Flow Direction Louvers will swing automatically to direct the airflow both up and down.
To Stop SWING Operation
Press the SWING LOUVER button (Fig. 6 R) once again.
The SWING indicator lamp (orange) (Fig. 3 7) will go out.
Airflow direction will return to the setting before swing was begun.
About Swing Operation
●The SWING range is as follows:
Cooling/Dry
mode
1 
3, (4 
7) NOTE
Fan mode
1 
3, 4 
7
●The SWING operation may stop temporarily when the air conditioner’s fan is not operating or when operating at very low speeds.
●The airflow direction can not be adjusted during SWING operation even when the AIR FLOW DIRECTION button is pressed.
NOTE
The air swings between 4 and 7 by pressing the SWING LOUVER button after selecting the air direction 6 (down- ward) by pressing the AIR FLOW DIRECTION button.
Use this operation when you want to cool yourself for a while after taking a bath or shower, or after coming back home in summer months.
But, for prevention of condensation on the louver, the swing of the air direction 4 ↔ 7 is automatically released after 30 minutes and turned to the swing of the air direc- tion 1 ↔ 3.
MANUAL AUTO OPERATION
Use the MANUAL AUTO operation in the event the Remote Control Unit is lost or otherwise unavailable.
How To Use the Main Unit Controls
Press the MANUAL AUTO button (Fig. 2 2) on the main unit control panel.
To stop operation, press the MANUAL AUTO button once again. (Controls are located inside the Intake Grille.)
●When the air conditioner is operated with the controls on the Main unit, it will operate under the same mode as the AUTO mode selected on the Re- mote Control Unit (see page 8).
●The fan speed selected will be “AUTO” and the thermostat setting will be standard.
