Fujitsu ASU18T, AOU36T Preparation, En-8, Load Batteries R03/LR03/AAA ⋅, Insert batteries

Models: ASU18T Room Air Conditioner Multi Split Type (3 rooms) AOU36T

1 25
Download 25 pages 29.14 Kb
Page 9
Image 9
PREPARATION

PREPARATION

Load Batteries (R03/LR03/AAA 4)

1Open the battery compartment lid.1 Slide the battery compartment lid until it stops.

2 While strongly gripping the portion on each side of the battery com- partment lid that has a rough surface, slide the lid until it comes com-

pletely off.

2

 

 

1

 

2

2

Insert batteries.

 

2

Be sure to align the battery polarities (

) correctly.

3

Close the battery compartment lid.

 

Set the Current time

 

 

1

Press the TIME ADJUST button.

 

 

Use the tip of a ball-point pen or other small object to press the button.

Load Batteries (R03/LR03/AAA ⋅ 4) CAUTION!

Take care to prevent infants from accidentally swallowing batteries.

When not using the remote control unit for an extended period, remove the batteries to avoid possible leakage and damage to the unit.

If leaking battery fluid comes in contact with your skin, eyes, or mouth, immedi- ately wash with copious amounts of water, and consult your physician.

Dead batteries should be removed immediately and disposed of properly, either in a battery collection receptacle or to the appropriate authority.

Do not attempt to recharge dry batteries.

Never mix new and used batteries, or batteries of different types.

Batteries should last about one year under normal use. If the remote control unit’s operating range becomes appre- ciably reduced, replace the batteries and press the ACL button with the tip of a ballpoint pen or other small object.

2Use the (Insert batteries.)SET TIME buttons to adjust the clock to the current time.

Close the battery compartment lid. button: Press to advance the time.

Set the Current time button: Press to reverse the time.

(Each time the buttons are pressed, the time will be advanced/reversed in one-minute increments; hold the buttons depressed to change the time quickly in ten-minute increments.)

SET

SWING

SET

ENERGY TIME RUN ACL

SAVE

3

Press the TIME ADJUST button again.

This completes the time setting and starts the clock.

To Use the Remote Control Unit

The remote control unit must be pointed at signal receiver to operate correctly.

Maximum operating range: Approximately 10 meters. (This may not apply when the battery is low or there are obstacles.)

When a signal is properly received by the air conditioner, a beep will be heard.

If no beep is heard, press the remote control unit button again.

Remote Control Unit Holder

For Hand-Held use
For Wall Mount use

Insert

Slide up

Insert

 

Screws

 

Screws

Slide

 

 

 

Screw

1 Mount the Holder. 2 Set the Remote

3 To remove the

1 Mount the Holder. 2 Set the Remote

3 Attach the unit to

Control Unit.

Remote Control

Control Unit.

the holder as

 

Unit.

 

shown.

En-8

Page 9
Image 9
Fujitsu ASU18T Preparation, En-8, Load Batteries R03/LR03/AAA ⋅, Insert batteries, Close the battery compartment lid