Fujitsu RX100 S2 - page 102

102
Chapter 3 OS Installation Using ServerStart
The server setup and OS installation have been completed.
Refer to "Chapter 5 Operations after OS Installation" (pg.125) and perform necessary procedures
before starting server operations.
●In Preconfiguration Mode
1Create a configuration file.
For the creation procedure, refer to "3.2 Preconfiguration Mode" (pg.71).
Specify the shared name of the prepared shared folder instead of the local CD-ROM as instal-
lation source information.
2Turn on the server and insert the ServerStart CD-ROM immediately.
ServerStart starts up and a message appears prompting you to insert the ServerStart floppy disk.
3Set the created configuration file and click [OK].
The [ServerStart Unattended Mode] window appears.
4Click [Start].
Installation starts. At steps where the CD-ROM for resources such as the OS to be installed is
necessary, the resource is automatically acquired from the resource server via the network.
5Eject the CD-ROM and floppy disk and click [OK].
The system restarts. When the installation is completed, an installation completion message
appears on the target server.
6Press any key on the target server.
7Restart the system on the target server.
The server setup and OS installation have been completed.
Refer to "Chapter 5 Operations after OS Installation" (pg.125) and perform necessary procedures
before starting server operations.