Turning the ScanSnap On/Off

25
Turning the ScanSnap On/Off
This section describes how to turn the ScanSnap on/off.
The ScanSnap is turned on/off in conjunction with the computer. Ordinarily, you do not need
to manually turn the ScanSnap on/off if it is connected to a computer.
•Turning the ScanSnap on
With the computer power on, open the ADF paper chute (cover).
⇒The [Scan] button blinks blue, indicating the ScanSnap is turning on.
•Turning the ScanSnap off
Turn off the computer or close the ADF paper chute (cover).
•ScanSnap Sleep state
When the ScanSnap is left open, it enters a "sleep" mode after 15 minutes without
use.
⇒In the sleep state, the ScanSnap internal lamps blink slowly.
The ScanSnap might perform initialization several times during startup.
•After putting the Extension away, close the ADF paper chute (cover).
•When stowing away the stacker, make sure that it does not become lose. If the
ADF paper chute (cover) is closed when the stacker is lose, the ScanSnap will
not be turned off.
•It may take 2 to 3 minutes until the [Scan] button goes off after the computer is
turned off.