Fujitsu S300M 2.2 Connecting the ScanSnap, ■Connecting the cable, See:, cable, Power cable, Power source, USB bus power, Use the following cable:

2.2 Connecting the ScanSnap

When the installation of the above programs is complete, connect the ScanSnap to your computer.

ATTENTION

Install ScanSnap Manager, and then restart your computer, before connecting the ScanSnap to your computer.

■Connecting the cable

Connect the ScanSnap to a power supply in either of two ways below:

Power source	Use the following cable:	See:
Power outlet		"When
	Power cable	connecting with
(When always operating		the Power
the ScanSnap at the same		cable:" (page 19)
regular place where it can	The Power
be fed power from a power	cable is a
outlet)
	combination of
	the AC adapter
	and AC cable.
Computer		"When
(When using the	USB bus power	connecting with
	cable	the USB bus
ScanSnap at a place		power cable:"
where it reaches no power		(page 20)
outlet, or when carrying the
ScanSnap together with
your laptop computer
around and operating at a
place where no power
outlet is available)

After connecting to a power source with the cable above, connect to your computer with a USB cable.

	Use only the AC cable and AC adapter (power cable) below:
CAUTION
	Otherwise, a failure may be caused.

•Manufacturer: LEI

•Model No.: NU13-1072166-I3

ScanSnap S300M Getting Started 18