6.Remove the Pick roller with its shaft.

Slightly pull up the left part of the Pick roller shaft about 1/5 inch (5 mm), move it towards the left side, and then raise it to remove from the scanner.

Pick roller shaft

 

Pick roller

ATTENTION

If the parts around the pick roller become dirty

 

because of paper-powder, it may cause a

 

scanning error. Please remove the dirt using a

 

dry cloth moistened with Cleaner F1.

*Don't use water, mild detergent or air-spray.

7.Remove the Pick roller from the shaft.Pull out the shaft from the Pick roller while lifting up its tab.

Tab

 

Pick roller shaft

 

Pick roller

ATTENTION

it may crack or chip your fingernail.

 

If you worry about that, push up the pick roller

 

tab using a paper clip.

 

1

2

8.Attach a new Pick roller to the shaft.Insert the Pick roller shaft aligning the key with the slot on the Pick roller.

 

Pick roller

 

Slot

Pick roller shaft

Key

16

9.Install the Pick roller with its shaft into the scanner. and set the shaft to the slot while lowering it.

Bushing

Pick roller shaft

Pick roller

10.Fix the Pick roller bushing (left) by rotating it in the direction of the arrow.

Pick roller

Pick roller

 

bushing

 

Pick roller

 

shaft

ATTENTION

Make sure that the Pick roller is completely

 

attached and correctly installed. Otherwise,

 

document jams or other feeding errors may

 

occur.

11.Attach the sheet guide to the scanner.

While holding the handle on the sheet guide, set the sheet guide into the scanner.

Sheet guide

Handle Craw

ÖYou should hear the sheet guide click when it returns to its original position.