49
APPENDIX C
Configuring the NetworkManagement Port
If your server uses system firmware 6.2 or subsequent compatible versions, do not
perform the following configuration. YourALOM CMT system controller network
management port is preconfigured at the factory.
If your server uses an earlier version of firmware than system firmware6.2, you
must configure the network management port before you can use it.
This appendix includes the following topic:
■Configuring the System Controller Network Manager Port

Configuring the System Controller

Network Manager Port

▼To Configure the System Controller Network

Management Port

Toaccess the system controller using the network for the first time, you must first
configurethe SC network management port through the SC serial management port.
Youset these network parameters according to the specific details of your network
configuration:
■if_network – Specified whether the SC is on the network or not
■netsc_ipaddr – IP address of the system controller
■netsc_ipgateway – IP address of the gateway for the subnet