Chapter 3 Powering On the System 31
Note – If you areunable to use DHCP and SSH on your network, you must connect
to the ALOM CMT system controller using the serial management port to
reconfigurethe network management port. See “To Configure the System Controller
Network Management Port” on page 31.
1. Open a Telnet or SSH session and connect to the system controller by specifying
its network address.
The following example shows a Telnetsession.
2. Login as admin using the password you previously set.

▼To Configure the System Controller Network

Management Port
Note – If your network allows the use of DHCP and SSH, this configuration is
performed automatically at the first time you boot the system.
Use this procedure only if:
■If you are unable to use DHCP and SSH on your network.
■If you need to modify the SC network management port settings.
In this procedure you connect to the ALOM CMT system controllerusing the serial
management port to manually reconfigure the network management port.
Note – For more information on configuring ALOM CMT,refer to the Advanced
Lights Out Management (ALOM) CMT Guide.
%telnet xxx.xxx.xx.xx
Trying xxx.xxx.xx.xx...
Connected to xxx.xxx.xx.xx.
Escape character is '^]'.
Advanced Lights Out Manager 1.x
Please login:
Please login: admin
Please Enter password: password
sc>