Fujitsu Siemens Computers B6210 manual Resume button. See Power Sources on

Models: B6210

1 128
Download 128 pages 59.73 Kb
Page 67
Image 67

B Series.book Page 59 Friday, May 19, 2006 3:00 PM

 

 

 

 

 

 

 

T r o u b l e s h o o t i n g

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Problem

Possible Cause

 

Possible Solutions

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Your LifeBook notebook

You are operating on battery

 

Install a power adapter and then push the Suspend/

 

 

turns off all by itself.

power and have ignored a low

 

Resume button. See “Power Sources” on page 29.

 

 

(continued)

battery alarm until the battery

 

 

 

 

is at the dead battery state and

 

 

 

 

 

 

 

 

 

 

your machine has gone into

 

 

 

 

 

Dead Battery Suspend mode.

 

 

 

 

 

 

 

 

 

 

 

 

 

You have a battery failure.

 

Verify the condition of the battery using the Status

 

 

 

 

 

 

 

 

Indicator panel, and replace or remove any shorted

 

 

 

 

 

 

 

 

battery. See “Status Indicator Panel” on page 13.

 

 

 

 

 

 

 

 

 

 

Your notebook will not

The installed battery is dead.

 

Replace the battery with a charged one or install

 

 

work on battery alone.

 

 

 

 

 

a power adapter.

 

 

 

 

 

 

 

 

 

 

 

No battery is installed.

 

Install a charged battery.

 

 

 

 

 

 

 

 

 

 

 

The battery is improperly

 

Verify that the battery is properly connected

 

 

 

installed.

 

by re-installing them.

 

 

 

 

 

 

 

 

 

 

 

Your installed battery is faulty.

 

Verify the condition of the battery using the

 

 

 

 

 

 

 

 

Status Indicator panel and replace or remove

 

 

 

 

 

 

 

 

any battery that is shorted. See “Status Indicator

 

 

 

 

 

 

 

 

Panel” on page 13.

 

 

 

 

 

 

 

 

 

 

The battery seems to

You are running an application

 

Use a power adapter for this application when at all

 

 

discharge too quickly.

that uses a great deal of power

 

possible.

 

 

 

due to frequent hard drive

 

 

 

 

 

access or CD-ROM access, use

 

 

 

 

 

of a modem or a LAN PC card.

 

 

 

 

 

 

 

 

 

 

 

 

 

The battery is very old.

 

Replace the battery.

 

 

 

 

 

 

 

 

 

 

 

The power savings features

 

Check the power management and/or setup utility

 

 

 

may be disabled.

 

settings in the Power Savings menu and adjust

 

 

 

 

 

 

 

 

according to your operating needs.

 

 

 

 

 

 

 

 

 

 

 

The brightness is turned all

 

Turn down the brightness adjustment. The higher

 

 

 

the way up.

 

the brightness the more power your display uses.

 

 

 

 

 

 

 

 

 

 

 

The battery has been exposed

 

Replace the battery.

 

 

 

to high temperatures.

 

 

 

 

 

 

 

 

 

 

 

 

 

The battery is too hot or too

 

Restore the notebook to normal operating tempera-

 

 

 

cold.

 

ture. The Charging icon on the Status Indicator

 

 

 

 

 

 

 

 

panel will flash when the battery is outside its

 

 

 

 

 

 

 

 

operating range.

 

 

 

 

 

 

 

 

 

 

Shutdown and Startup Problems

 

 

 

 

 

 

 

 

 

 

 

 

The Suspend/Resume

The Suspend/Resume button

 

Enable the button from the setup utility.

 

 

button does not work.

is disabled from the Advanced

 

 

 

 

 

submenu of the Power menu

 

 

 

 

 

of the setup utility.

 

 

 

 

 

 

 

 

 

 

 

 

 

You did not hold the button

 

Hold the button longer. This may need to be a few

 

 

 

in long enough.

 

seconds if your application is preventing the CPU

 

 

 

 

 

 

 

 

from checking for button pushes.

 

 

 

 

 

 

 

 

 

 

 

There may be a conflict with

 

Close all applications and try the button again.

 

 

 

the application software.

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

59

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

 

Page 67
Image 67
Fujitsu Siemens Computers B6210 manual Resume button. See Power Sources on, Shutdown and Startup Problems