Fujitsu Siemens Computers B6210 manual Care and Maintenance, Lifebook Notebook

B Series.book Page 69 Friday, May 19, 2006 3:00 PM

Care and Maintenance

If you use your LifeBook notebook carefully, you will increase its life and reliability. This section provides

some tips for looking after the notebook and its devices.

■The system contains components that can be severely damaged by electro- static discharge (ESD). To minimize risk to the components, observe the following precautions:

■Before docking or undocking your LifeBook notebook (when using a port replicator), it is a good practice to always touch a grounded metal object to discharge static electricity built up in your body.

■Be sure to power down your system before adding or removing system components. Even if the system is in hibernate or standby states, data could be lost or memory could be damaged if power is still available to the system.

■When installing or removing a memory module, hold it by the edge so as not to touch any contacts or chips. Be careful not to touch any internal computer terminals or compo- nents; the oil from your fingers could cause a short to the components.

■Electrical equipment may be hazardous if misused. Operations of this product or similar products, must always be super- vised by an adult. Do not allow children access to the interior of any electrical products and do not permit them to handle any cables.

LIFEBOOK NOTEBOOK

Caring for your LifeBook notebook

■Your LifeBook notebook is a durable but sensitive electronic device. Treat it with care.

■Make a habit of transporting it in a suitable carrying case.

■To protect your notebook from damage and to opti- mize system performance, be sure to keep all air all vents unobstructed, clean, and clear of debris. This may require periodic cleaning, depending upon the environment in which the system is used.

■Do not operate the notebook in areas where the air vents can be obstructed, such as in tight enclosures or on soft surfaces like a bed or cushion.

■Do not attempt to service the computer yourself. Always follow installation instructions closely.

■Keep it away from food and beverages.

■If you accidentally spill liquid on your notebook:

1.Turn it off.

2.Position it so that the liquid can run out.

C a r e a n d M a i n t e n a n c e

3.Let it dry out for 24 hours, or longer if needed.

4.If your notebook will not boot after it has dried out, call your support representative.

■Do not use your notebook in a wet environment (near a bathtub, swimming pool).

■Always use the AC adapter and batteries that are approved for your notebook.

■Avoid exposure to sand, dust and other environmental hazards.

■Do not expose your notebook to direct sunlight for long periods of time as temperatures above

140° F (60° C) may damage your notebook.

■Keep the covers closed on the connectors and slots when they are not in use.

■Do not put heavy or sharp objects on the computer.

■If you are carrying your notebook in a briefcase, or any other carrying case, make sure that there are no objects in the case pressing on the lid.

■Do not drop your notebook.

■Do not touch the screen with any sharp objects.

Cleaning your LifeBook notebook

■Always disconnect the power plug. (Pull the plug, not the cord.)

■Clean your notebook with a damp, lint-free cloth. Do not use abrasives or solvents.

■Use a soft cloth to remove dust from the screen. Never use glass cleaners.

Storing your LifeBook notebook

■If storing your notebook for a month or longer, turn the notebook off, fully charge the battery, then remove and store all Lithium ion batteries.

■Store your notebook and batteries separately. If you store your notebook with a battery installed, the battery will discharge, and battery life will be reduced. In addition, a faulty battery might damage the note- book.

■Store your notebook in a cool, dry location. Temperatures should remain between -25ºC (13ºF) and 60ºC (140ºF).

Traveling with your LifeBook notebook

■Do not transport your notebook while it is turned on.

■Do not check your notebook as baggage. Carry it with you.

■When traveling with the hard drive removed, wrap the drive in a non-conducting materials (cloth or paper). If you have the drive checked by hand, be ready to install the drive if needed. Never put your hard drive through a metal detector. Have your hard drive hand- inspected by security personnel. You can however, put your hard drive through a properly tuned X-ray machine.

■Take the necessary plug adapters if you're traveling overseas. Check the following diagram to determine which adapter you'll need or ask your travel agent.

69