6.Remove the cable clamping plate by
Shield cover | Screws | |
Screws | 4 pcs. | |
Cable clamping plate | ||
7 pcs. | ||
Shield cover | Gasket | |
|
Screws 
7 pcs. 
Screws 6 pcs.
Shield cover
Figure 6-5 Antenna unit, inside view
7.Pass the cable through the hole at the bottom of the radome base.
8.Secure the cable with the cable clamping plate and gasket. Ground the shield and vinyl wire by one of the screws of the cable clamping plate.
9.Connect the wire to the RF unit.
Figure 6-6 Signal cable, antenna unit side
Figure 6-7 RF unit
9.Attach the EMC core supplied as shown below.
Figure 6-8 How to attach EMC core
11.Fix the shield cover. Do not pinch the cable.
12.Attach the radome cover, aligning triangle mark on radome cover with that on radome base.
13.Loosely fasten the radome fixing bolts. You will tighten them after confirming magnetron heater voltage.
Mounting (Model 1932, 1942)
Figure 6-10 Typical antenna unit mounting
locations
1.Drill four fixing bolt holes (13 millimeters.), one cable entry hole (approx. 50
27
