5. Clean the main shaft and pass it through the main body flange.
Check that
Main body flange
Figure 1-7 Passing main shaft through the main body flange
6.Set the grease cotton to the main body flange and tighten the grease cotton retainer temporarily.
Wind grease cotton onto main shaft and cut it as shown below.
Space joints of grease cotton 120° apart and push them into body flange.
Flat washer
Figure 1-8 Installing grease cotton on the main shaft
7.Temporarily fasten the fastening band onto the main shaft at the location shown below.
Lt: Tank Length | Lt - 430 mm |
Fastening band
Figure 1-9 Fastening the fastening band on the main shaft
8.Inscribe bow mark at the top of the main shaft. Pass pipe clamp through the main shaft and install washer, gasket, and cable gland.
