４．３ Terminal board
Use terminal board on the rear panel of the main unit for the connection between BK, external receiver or decoder. Insert a connection wire in a terminal in the following ways.
|
| Push knob |
| Press a push knob by |
|
| a screwdriver |
|
Peel | off vinyl sheath |
|
of the wire about 10mm |
| |
| Connection | Terminal board |
| wire | Wire hole |
Insert a connection wire to a hole while pressing the push knob
Note: Use connection wire with single core 0.4~1.0mmØ or standard twist core 0.3mm2~0.7mm2.
４．３．１ Connection of BK
Connect BK referring to attached “Layout diagram” in the APPENDIX.
BK voltage is 12 ～ 24 VDC, no polarity.
BK cable is not included in the standard supply scope.
４．３．２ Connection with external receiver
Connect with external receiver referring to article 2.5 “Operation with external receiver” (page 17).
- 21 -
