5.Press the Reset button on the GSC 10. The LED turns red, then green. Pedal to test the sensor alignment. The red LED blinks each time the crank arm passes the sensor, and the green LED blinks each time the wheel magnet passes the sensor arm.

note: The LED blinks for the first 60 passes after a reset. Press Reset again if you require additional passes.

6.When everything is aligned and working correctly, tighten the cable ties, sensor arm, and spoke magnet.

Using Accessories

Training with Cadence

Cadence is your rate of pedaling or “spinning” measured by the number of revolutions of the crank arm per minute (rpm). There are two sensors on the GSC 10: one for cadence and one for speed.

For information about cadence alerts, see page 19.

For information about speed zones, see page 56.

GSC 10 Battery

For GSC 10 battery information, see page 61.

Edge 605/705 Owner’s Manual