Garmin FA168CPS manual About Scheduling, Creating Schedules, Relay Number

1 DISARMED READY TO ARM

ENTER SCHED NO.

00=QUIT 00

ENTER EVENT CLEAR EVENT 00

Scheduling

About Scheduling

The system provides end-user schedules (programmable by master/installer only), which can control various types of events.

•Each schedule causes a defined event to start and stop (when appropriate) at a specified time.

•Schedules can be set to automatically repeat at various intervals.

•Schedules can be set for random starting, if desired.

•FA168CPS provides up to 16 user schedules; FA148CP provides up to 4 user schedules.

Creating Schedules

Alpha Displays:

1.

(Master Code)

+ [#] + [6] [4]

2.Enter a 2-digit schedule number from:

01-16 (FA168CPS) or 01-04 (FA148CP). Press [∗] to continue.

3.Enter the desired 2-digit event number from the

following list.

00 = clear the scheduled event

01 = turn a programmed output on or off

(see Using Device Commands section for a list of output device numbers used in your system)

02 = set a user access schedule for one or more users

(see Security Codes section for an explanation of access groups)

03 = send a “latch-key” report to a pager if the system is not disarmed by a specified time; message sent is “777-7777.”

04 = automatically arm the system in STAY mode at a specified time

05 = automatically arm the system in AWAY mode at a specified time 06 = automatically disarm the system at a specified time

07 = Display the word “REMINDER” at a specified time (if selected, the keypad beeps every 30 seconds beginning when the word “REMINDER” is first displayed, and the display alternates with the normal keypad display about every 4-5 seconds. To stop the beeps and cancel the display once it starts, simply press any key).

Press [∗] to continue.

4.For event number “01,” enter the output number associated with this schedule.

Otherwise, this prompt is skipped.

Press [∗] to continue to the “Start” prompt shown on the next page.

RELAY NUMBER

00

– 35 –