GarrettCom 4K-Series manual Installing FPM Cards in the Magnum 4K8 Switches, Before insertion

Magnum 4K8 Switches Installation and User Guide (10/04)

Step 2. Remove bottom-front Retaining Screws in any PM or Face Plates

On the bottom-front of the unit, there is one retaining screw for FPM card slot. These screws are used to secure a FPM face plate in position. These screws are also used to secure the individual FPM cards, which can be subjected to significant forces from the attached cables. (See Figure 3.4.1c)

MAGNUM 4K-Series Ethernet 10/100 Switch

POWER	SPEED 1	2	3	4	5
ERROR	L/A
UPLINK	F/H

= X

6 7 8 A L

H

	F
F	H

BOTTOM-Front FPM

Retaining Screws

Figure 3.4.1c: Front View - FPM Retaining Screws hold Face Plates

PM card installation is covered in Section 3.4.2. FPM card removal is covered in Sect.3.4.3.

3.4.2Installing FPM Cards in the Magnum 4K8 Switches

Up to sixteen front-mounted FPM card may be installed in one Magnum 4K8 Switch unit. Follow these steps to install a FPM.

Step 1. Remove front-top chassis	cover. See procedure in					Section 3.4.1
above.
Step 2. The figure here illustrates			LED	TOP
the basic layout of an					Printed Circuit card
individual FPM card. Each
FPM card fits into the							Ten(10) Pin
selected FPM connector
							FPM Connector
socket slot. Align the						(inserts into main board)
		Bottom FPM Retaining
connector pins on the			Screw Hole
bottom of the FPM card with the connector socket inside the unit. The pins are
slightly angled to facilitate the installation. (Do NOT straighten the pins
before insertion !!)

www . GarrettCom . com

20